On the page Faema E61 pump parts you will find a variety of parts for your Faema e61 espresso machine. With a Faema E61 espresso machine the pump and motor are placed outside the machine instead of the nowadays standard inside the machine (yes there are still machines, like kees van der Westen. Who install their pump and motor outside the machine)
The functioning of a Faema E61 pump system is as follows. When the lever is raised a micro control lever is pushed down and this will move a other control lever. This will push a microswitch and the espresso machine pump starts to run. When it is lowered again the espresso machine motor will stop again.
It is advisable to use a motor like a RPM clamp ring motor with a junction box, this junction box will seal it from any water. Can be handy when your pump is out in the open under a bar.
The pump type which goes with a clamp ring motor is a clamp type of espresso machine pump. These rotary vane pumps are clamped to the motors. You can use a variety of brands for this like Fluid o tech, Nuert or Procon.
If you have any other questions don’t hesitate to contact us.
The espresso machine motor on this page is made by the Italian electric motor manufacturer RPM. This motor is intended to be used as a exterior motor, so that it isn’t installed inside the machine. The motor is a good motor to use with a vintage espresso machine like the Faema E61. Currently this coffee machine motor can be used on a variety of...
The rotary vane espresso machine pump. There are various brands which manufacture these pumps like Fluid o tech, Nuert and Procon. The pump on this page is made by the company Procon. Part number 132A060F123B The pump on this page is called a rotary vane clamp pump. The pump is clamped on a flange with a stainless steel clamp. If you tighten this clamp...
On this product page you will find a brass espresso machine pump. This pump can be used on espresso machine brands such as Astoria and Wega. The part references for this rotation pump is for Astoria 26303 and for Wega WY26303 This rotary vane espresso machine pump has been made by the Italian company Fluid o Tech. This model is a clamp on...
On this page you will find a stainless steel water hose. This hose can be used to connect the water mains to your espresso machine any other suitable appliance. This stainless steel flex hose has a overall length of 2000mm and on each end a 3/8” BSP-G fitting. This connection is conical so there is no need to a gasket. The maximum fluid temperature...
The flexible tube on this page has a overall length of 1500mm. This includes the fittings. The fittings on this pipe are female 3/8” BSP-G and both have a conical base, so there is no gasket needed. The tubes are rated up to 10 bar and with a maximum working temperature of 90 degree Celsius.
On this product page you will find a microswitch which can be used on the Faema E61 espresso machines. As well on the Faema E61 Legend espresso machines. The Faema part reference for this switch is Faema 532006600. This switch is rated up to 16A at 250V. This switch has a spring loaded metal pin. This pin get’s pushed inwards when the lever of the...
Cookie | Provider | Purpose | Expiry |
---|---|---|---|
PHP_SESSID | brooks-parts.com | The PHPSESSID cookie is native to PHP and allows websites to store serialised status data. On the website it is used to establish a user session and to pass state data through a temporary cookie, which is commonly known as a session cookie. These Cookies will only remain on your computer until you close your browser. | Session |
PrestaShop-# | brooks-parts.com | This is a cookie used by Prestashop to store information and keep the user's session open. It stores information such as currency, language, customer ID, among other data necessary for the proper functioning of the shop. | 480 hours |