Valve rod spring 15x17mm
€0.74 tax excl.
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
The compression spring on this page knows a variety of applications with various brands. You can use this spring with brands like Vibiemme, La Scala, Faema, Spaziale and Brasilia. As for instance on steam and water valves. The part references can be found in the extra info tab
This stainless-steel compression spring has a outer diameter of 15mm and a overall length of 17mm. This item has been made in Italy.
The complete list of models can be found in the extra info tab.
Data sheet
- Brand
- Brasilia
Faema
La Scala
La Spaziale
Vibiemme - Brasilia
- Bar-America
- Country of manufacturing
- Made in Italy
- Faema
- E61
E61 Jubile
E61 legend
E64
E66
Faema E61 Jubilé A1
Faema E61 Jubilé A2
Faema E61 Legend S1
Faema E61 Legend S2
Faema E61 Legend S3
P4 - La Scala
- Eroica
- La Spaziale
- New
New E.P.
New EK
Rapid
Rapid E.P.
Rapid EK
S1
S3
S3 EK
S3 EP - Length
- 17mm
- Outer diameter (OD)
- 15mm
- part number
- Brasilia 00879.0.00.03
Faema 4731135883
Spaziale 00522
Vibiemme MOLLPGRUBACVA - Type part
- Compression spring
- Vibiemme
- Chimaera
Cubo
Dosaplus
Replica
Well that answer is pretty simple, no it isn’t. The original valve works as following, when you turn the shaft inwards the valve pin will push a gasket holder. The steam can go out, close it again and no steam can go out. In the case of the modern E61 valves is that behind the gasket holder is a small stainless steel ball with a spring.
From the beginning of the Faema E61 brewing group are basically no differences between the parts installed inside the brewing group. Parts such as the valve gaskets, springs, valve assemblies and portafilters have all remained the same. The biggest change is the small cleaning hole on the front of the brewing group. With the earliest models this hole didn´t exist.
There are 5 types of boiler used on the Faema E61 espresso machine. The most well known is the double flanged model. You have on one side the heating element flange and on the other side the water level flange, both are out of production. These are held in place with aluminium boiler rings. For the single groups you have a boiler with a flange on one side.
The next model is a stainless steel boiler, with one flange. This type of boiler is less common then the copper boiler above. There is also a later model stainless steel, which doesn’t have a removable flange. Both these boilers have corrosion issues, this has to do because of the stainless steel.
The latest model is also a copper boiler, this boiler has a single heat exchanger(HX) in the middle. Most modern espresso machines have for each individual brewing group a individual HX.
Yes it is, but this depends on various factors. The first thing is experience, seen this is a manual operated espresso machine it requires a lot more attention from the barista then a solenoid operated model. There you need to stop the brewing process manually. If you don’t have the experience you probably can’t hold up with the tempo which is required at such a bar. Then I would advice to go for the Faema E61 Jubilee, this is the solenoid operated version of the Faema E61 Legend espresso machine.