Faema E61 water level spring
search
  • Faema E61 water level spring

Faema vannnivåspråket 22x20mm


€ 2.77
Inklusive MVA

€ 2.29 eks. mva.

qty

  GDPR-overholdelse

Beskytte dine personlige data

  Fraktpolicy

Alt om frakt av bestillingen din

  Returpolicy

alle inns og outs om vår returpolicy

På denne sida finn du ein trykkspring av rustfritt stål som vert brukt på ulike Faema viseglassamansettingar. Denne våren vert brukt til å halda eit likt trykk på siktglasspakningen. Den Faema delreferanse for dette elementet er 4731018635.

Denne trykksprøya av rustfritt stål har ein ytre diameter på 22 mm og ei høgd på 20 mm.

Du kan bruka denne kompresjonsfjelen på Faema modellane Faema E61. Faema P4, Faema P6, Faema E64, Faema E66, Faema No Stop og Faema Stjerne.

Merknad: Dette elementet er ikkje egnet for Faema E61 Legend og Faema E61 Jubile.

Faema
32-102-L-1250401
18 Produkter

Dataark

delenummer
Faema 4731018635
Faema
E61
E64
E66
Lambro
P4
President
Star
Merke
Faema
Tykkelse
20mm
Ytre diameter (OD)
22mm

Well that answer is pretty simple, no it isn’t. The original valve works as following, when you turn the shaft inwards the valve pin will push a gasket holder. The steam can go out, close it again and no steam can go out. In the case of the modern E61 valves is that behind the gasket holder is a small stainless steel ball with a spring.

From the beginning of the Faema E61 brewing group are basically no differences between the parts installed inside the brewing group. Parts such as the valve gaskets, springs, valve assemblies and portafilters have all remained the same. The biggest change is the small cleaning hole on the front of the brewing group. With the earliest models this hole didn´t exist.

There are 5 types of boiler used on the Faema E61 espresso machine. The most well known is the double flanged model. You have on one side the heating element flange and on the other side the water level flange, both are out of production. These are held in place with aluminium boiler rings. For the single groups you have a boiler with a flange on one side.

The next model is a stainless steel boiler, with one flange. This type of boiler is less common then the copper boiler above. There is also a later model stainless steel, which doesn’t have a removable flange. Both these boilers have corrosion issues, this has to do because of the stainless steel.

The latest model is also a copper boiler, this boiler has a single heat exchanger(HX) in the middle. Most modern espresso machines have for each individual brewing group a individual HX.

Yes it is, but this depends on various factors. The first thing is experience, seen this is a manual operated espresso machine it requires a lot more attention from the barista then a solenoid operated model. There you need to stop the brewing process manually. If you don’t have the experience you probably can’t hold up with the tempo which is required at such a bar. Then I would advice to go for the Faema E61 Jubilee, this is the solenoid operated version of the Faema E61 Legend espresso machine.

Kommentarer (0)
Ingen kundeanmeldelser enda.

8 other product