IMS filter basket removal tool
search
  • IMS filter basket removal tool

IMS filter basket removal tool

€8.91
VAT included

€7.36 tax excl.

qty
Last items in stock

compare
  Security policy

(edit with the Customer Reassurance module)

  Delivery policy

(edit with the Customer Reassurance module)

  Return policy

(edit with the Customer Reassurance module)

When you want to clean your portafilter at the end of the day you need to remove the filter basket from the portafilter. But these baskets are normally held in place with the internal spring and can be difficult to remove. Instead of removing the basket with a spoon IMS Filtri has made a filter basket removal tool.

This tool is made from stainless steel. On one side you have a round hole to hang it on a key chain and on the other side you have the removal section. The side you need to place under the basket is slightly thinner then the rest of the tool.  You place the tool under the edge of the basket in the region where the portafilter ears are located, this is done for extra leverage. This tool is made in Italy.

55-591-9V0010
3 Items
Can I use any filterbasket in my double portafilter? insert_link

No you can’t. The most common size of double filterbaskets has a diameter of 70mm. This is found on for instance Faema and Nuova Simonelli portafilters. The 68mm is typical for Cimbali espresso machines. Where you have smaller sizes for La Spaziale and San Marco portafilters.

Is a vintage E61 steam valve the same as the modern steam valves? insert_link

Well that answer is pretty simple, no it isn’t. The original valve works as following, when you turn the shaft inwards the valve pin will push a gasket holder. The steam can go out, close it again and no steam can go out. In the case of the modern E61 valves is that behind the gasket holder is a small stainless steel ball with a spring.

Are there differences between the Faema E61 brewing groups? insert_link

From the beginning of the Faema E61 brewing group are basically no differences between the parts installed inside the brewing group. Parts such as the valve gaskets, springs, valve assemblies and portafilters have all remained the same. The biggest change is the small cleaning hole on the front of the brewing group. With the earliest models this hole didn´t exist.

How many types of boilers are there on the Faema E61? insert_link

There are 5 types of boiler used on the Faema E61 espresso machine. The most well known is the double flanged model. You have on one side the heating element flange and on the other side the water level flange, both are out of production. These are held in place with aluminium boiler rings. For the single groups you have a boiler with a flange on one side.

The next model is a stainless steel boiler, with one flange. This type of boiler is less common then the copper boiler above. There is also a later model stainless steel, which doesn’t have a removable flange. Both these boilers have corrosion issues, this has to do because of the stainless steel.

The latest model is also a copper boiler, this boiler has a single heat exchanger(HX) in the middle. Most modern espresso machines have for each individual brewing group a individual HX.

Is the Faema E61 espresso machine suitable for a busy bar/café insert_link

Yes it is, but this depends on various factors. The first thing is experience, seen this is a manual operated espresso machine it requires a lot more attention from the barista then a solenoid operated model. There you need to stop the brewing process manually. If you don’t have the experience you probably can’t hold up with the tempo which is required at such a bar. Then I would advice to go for the Faema E61 Jubilee, this is the solenoid operated version of the Faema E61 Legend espresso machine.

Comments (0)
No customer reviews for the moment.

8 other product