Faema E61 steam valve knob
€12.19 tax excl.
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
(edit with the Customer Reassurance module)
The steam and water valve knob on this page is mainly famous as the knobs used on the classic Faema E61 espresso machines. But nowadays they are used in a variety of other brands as well. Like with Vibiemme, La Scala and Grimac. This type of knob can also be used on the modern Faema E61 legend and Jubilee espresso machines. For the part references check the extra info tab.
This steam and water valve has been made from a black plastic, so not Bakelite like the old original ones. In the middle of this knob is s brass square which has an opening of 7x7mm.
This handle/knob can be used on the espresso machine models: Grimac Zola II, Faema E61, Faema E61 legend, Faema E61 jubilee, Vibiemme Chimaera, Vibiemme Cubo, Vibiemme Replica and the La Scala Eroica.
Data sheet
- Brand
- Faema
Grimac
La Scala
Vibiemme - Country of manufacturing
- Made in Italy
- Faema
- E61
E61 Jubile
E61 legend
Faema E61 Jubilé A1
Faema E61 Jubilé A2
Faema E61 Legend S1
Faema E61 Legend S2
Faema E61 Legend S3 - Grimac
- Zola-II
- La Scala
- Eroica
- part number
- Expobar 40000080
Faema 4831135881
Grimac 2210200003-GR331
Scala C-0199
Vibiemme MANPRUVAACRE - Vibiemme
- Chimaera
Cubo
Replica
Well that answer is pretty simple, no it isn’t. The original valve works as following, when you turn the shaft inwards the valve pin will push a gasket holder. The steam can go out, close it again and no steam can go out. In the case of the modern E61 valves is that behind the gasket holder is a small stainless steel ball with a spring.
From the beginning of the Faema E61 brewing group are basically no differences between the parts installed inside the brewing group. Parts such as the valve gaskets, springs, valve assemblies and portafilters have all remained the same. The biggest change is the small cleaning hole on the front of the brewing group. With the earliest models this hole didn´t exist.
There are 5 types of boiler used on the Faema E61 espresso machine. The most well known is the double flanged model. You have on one side the heating element flange and on the other side the water level flange, both are out of production. These are held in place with aluminium boiler rings. For the single groups you have a boiler with a flange on one side.
The next model is a stainless steel boiler, with one flange. This type of boiler is less common then the copper boiler above. There is also a later model stainless steel, which doesn’t have a removable flange. Both these boilers have corrosion issues, this has to do because of the stainless steel.
The latest model is also a copper boiler, this boiler has a single heat exchanger(HX) in the middle. Most modern espresso machines have for each individual brewing group a individual HX.
Yes it is, but this depends on various factors. The first thing is experience, seen this is a manual operated espresso machine it requires a lot more attention from the barista then a solenoid operated model. There you need to stop the brewing process manually. If you don’t have the experience you probably can’t hold up with the tempo which is required at such a bar. Then I would advice to go for the Faema E61 Jubilee, this is the solenoid operated version of the Faema E61 Legend espresso machine.