Faema E61 steam/water valve body

The o ring on this page can be used in various applications in espresso machines. This ranges from water and steam valves, water inlet taps and water levels. The part on this page is a O ring made from the material EPDM. This o ring has a cord diameter of 2,7mm and a inner diameter of 12,1mm. This o ring is produced in Italy. You will find this o ring...

The item on this product page is a adjustable expansion valve. This valve is a generic spare part and can be used on various espresso machines. This expansion valve is made from brass. the fitting used is a 3/8” BSP-G thread. on the other side is a hose fitting for 10mm tubes. This expansion valve is adjustable with a range which goes from 10 to 14...

On this page you will find the touchpad panel for the Faema E61 Jubilee A2, so for the 2 group version. The Faema part reference for this item is 903-007-008 The touchpad panel has a length of 468mm and a width of 43mm. This panel does not come with the keys itself which have the Faema part reference of 903-003-007

In some cases, the shower screen is attached with a screw, in most cases that is a Philips or a slotted screw. It is difficult to remove it with a regular screwdriver due to the limited height under the brew group.  But for that you need a shortened slotted screwdriver, in this case the one from the German brand Wera, which fits well under the brewing...

The non return valve on this product page can be used on various Faema and Cimbali water inlet valves. The part references for this item are for Cimbali 3211029421 and 3211-029-421. For Faema the part reference is 2211029421 and 3211029421   This non return valve has only 1 conical seal. The back of the valve holder is for just a small compression spring...

On this product page you will find a brass hose barb with a male fitting. The fitting used is a ½” BSP-G thread. The widest section where the tube slides over is 16,5mm. The inner tube has a inner diameter of 10mm. To install a hose over this you will always need to apply a hose clamp, otherwise the hose will come loose.

The pump on this page is a OEM/Original Cimbali/Faema rotation pump. But this pump is slightly different, most pumps are made from casted brass but these are made from stainless steel. This pump has been made by the Italian company Fluid o tech. The part references for this pump can be found in the extra info tab. This pump has the name Compact plus and...

This O ring in nbr with the specifications 8,9x1,9mm. Makes sure that the brass non return valve seals against the body of the non return valve. Return to the Faema E61 valve parts overview