Brass hose barb 3/8" M dia 12mm

On this product page you will find a brass hose barb with a male fitting. The fitting used is a ½” BSP-G thread. The widest section where the tube slides over is 16,5mm. The inner tube has a inner diameter of 10mm. To install a hose over this you will always need to apply a hose clamp, otherwise the hose will come loose.

On this product page you will find a brass hose barb. This brass hose barb has a male thread of 3/8” BSP-G. The part where the hose slides over has a diameter of 9mm. To keep the hose clamped into it’s place you need to use a hose clamp.

On this product page you will find a brass hose barb with a female fitting. The fitting used is a ½” BSP-G thread. The widest section where the tube slides over is 16,5mm. The inner tube has a inner diameter of 10mm. To install a hose over this you will always need to apply a hose clamp, otherwise the hose will come loose.

On this page you will find a brass hose end fitting, but it is just 1 part of 2. The other item is a 3/8”nut with a hole in it, you will find it with the accessory tab. This brass fitting has on the connecting side a conical shape, so there is no seal required. The end fitting where the hose attaches has a diameter of 8mm.

On this page you will find a brass hose barb. This brass hose barb has a male screw thread of ½”BSP-G. On the other side you can slide a hose over it. The diameter of the smallest section is 6mm and the widest section is 11mm. To keep the hose in it’s place you will need to clamp a hose clamp around this fitting.