Eureka / Nuova Simonelli Mythos hopper big

This burr holder is used on a couple of coffee grinder brands. Nuova Simonelli (15080009 ) and Eureka(2520.0005). On this part the bottom burr (15030057) is also attached with 3 screws. This is also the rotating burr, seen it is attached to the motor shaft. On which grinders can I use this burr holder? On the Nuova Simonelli MDL, Nuova Simonelli MDLCA and...

These original Eureka grinding blades can be used on some Eureka and Nuova Simonelli coffee grinders. This item always comes in a Eureka packaging This specific model grinding blades has a base of tool steel base and over it a Titanium layer applied. This layer of Titanium is much harder then the tool steel and has a low friction coefficient. So these...

This small component is used in a variety of Nuova Simonelli espresso machines, it is used the de-clump the ground coffee. This specific item is a OEM/original Nuova Simonelli spare part and has the part reference number  15030079. This clump crusher is used on a variety of espresso machines, do check the part diagrams if the part numbers match seen there...

This capacitor is a OEM/Original spare part for Nuova Simonelli and Victoria Arduino coffee grinders. The Part reference number for this item is 15030027 This specific capacitor is used on the 110V versions of the Mythos grinders. It produces 60uf and it is used for single phase motors. This capacitor has been made in Italy.

With this knob you can se the grind settings of the coffee grinder to finer or coarser. This specific item is a OEM/original spare part and has the part reference number 15030098. This adjustment knob can be used on various Nuova Simonelli models such as Nuova Simonelli MDJ, MDJ on demand and the Mythos, Mythos one and the Mythos 2.

This microswitch is used on Nuova Simonelli and Victoria Arduino Mythos coffee grinders. This switch indicates if the coffee hopper is installed, otherwise the grinder won’t work. The part reference number for this item is 15030002.This microswitch is rated up to 10A at 250V

This set of coffee grinding burrs can be used on various Nuova Simonelli and Victoria Arduino coffee grinders. The Nuova Simonelli part reference number is 15080002 and for Victoria Arduino this is 15080002. This set of grinding burrs is a OEM/Original set of Nuova Simonelli grinding burrs. The outer diameter of these grinding burrs is 75mm. You can use...

This electronic display on this page is used in Eureka and Nuova Simonelli coffee grinders. This item is only suitable for the coffee grinder model Mythos. The part contains the display and the 5 push buttons for the dose settings. This item doesn’t come with the membrane. The part number for Nuova Simonelli is 15030011 and the Eureka part number...